By BugsNPests · Last reviewed 17 November 2026 · 7 minute read
Quick answer: a mouse can squeeze through a gap of about a quarter inch (6 mm), roughly the width of a pencil. To keep mice out, check every pipe, vent, door, garage seal, foundation crack and roofline gap, and close each one with a material mice cannot chew through, such as metal mesh, metal flashing, cement patch or a sealant over mesh. Foam or paper alone will not hold.
Key takeaways
- Quarter-inch gaps are enough. Walk the whole house, inside and out.
- Use metal, mesh, cement or sealant over mesh. Mice chew through foam, paper and plastic.
- Remove mice before you seal, or you can trap them inside the walls.
- Never block furnace, water heater or gas meter vents.
- No home can be guaranteed mouse-free forever, so check again each spring and fall.
Already hearing scratching? Call 780-716-3943 or WhatsApp us a photo. We find the entry points and seal them.
Start With the Right Tools and Materials
| Item | Use it for |
|---|---|
| Flashlight and small mirror | Looking behind pipes and into dark corners |
| Hardware cloth or metal mesh (about ¼ inch) | Covering vents, larger holes and gaps |
| Metal flashing or sheet metal | Covering chewed corners and edges |
| Copper mesh or steel wool | Packing small gaps behind sealant |
| Exterior sealant or caulk | Holding mesh in place and sealing small cracks |
| Cement or masonry patch | Foundation cracks and holes |
| Door sweeps and weatherstripping | Doors and garage doors |
| Screen or vent covers | Dryer, furnace and roof vents |
Room-by-Room Checklist
| Area | What to check | How to seal it | Done |
|---|---|---|---|
| Foundation and siding | Cracks, gaps where siding meets concrete, openings near ground level | Cement or masonry patch for cracks, mesh with sealant for gaps | ☐ |
| Pipes, gas lines and cables | Gaps around where they enter the house | Pack with mesh, then sealant. Fit a metal collar if the gap is large | ☐ |
| Dryer and exhaust vents | Missing or damaged covers | Replace with a vent cover that has a flap and mesh guard | ☐ |
| Garage door | Worn or cracked bottom seal, side gaps | Replace the bottom seal and add side weatherstripping | ☐ |
| Exterior doors | Daylight under the door or at the sides | Door sweep and weatherstripping | ☐ |
| Windows and screens | Torn screens, gaps around frames | Repair screens and caulk the frame | ☐ |
| Roofline, soffits and vents | Gaps, loose vent covers, chewed edges | Metal flashing or mesh. Use a ladder safely or call a pro | ☐ |
| Chimney | Missing cap | Install a chimney cap | ☐ |
| Basement and crawl space | Vent openings, gaps around utility lines | Mesh over vents and sealant around lines | ☐ |
| Inside the house | Gaps behind sinks and appliances, holes in cabinets | Mesh and sealant in gaps behind sinks and appliances | ☐ |
How to Do an Entry Point Walk-Around
- Start outside at ground level. Walk the foundation slowly. Look for cracks and holes about a quarter inch or larger.
- Check where anything enters the house: gas meter lines, air conditioner lines, cables and water pipes.
- Look at doors and the garage. If you can see light under or beside a door, a mouse can get in.
- Check vents and the roofline. Use binoculars or a ladder carefully. Look for chewed edges and loose covers.
- Go inside. Check under sinks, behind the stove and fridge, around pipes in the basement and in the attic.
- Mark every gap with tape and take photos before you start fixing.
What Materials Mice Cannot Chew Through
Best: metal mesh or hardware cloth, copper mesh, sheet metal flashing, cement or masonry patch.
Good support: exterior sealant to hold mesh in place and seal small gaps.
Weak on their own: expanding foam, paper, plastic, wood and caulk alone. Mice chew through them.
Sealing Safely: What Not to Do
If you find droppings while you work, clean up safely: ventilate, wear gloves, soak droppings with a bleach and water mix (1 part bleach to 9 parts water) or a household disinfectant, wipe with paper towels and bag them. Never sweep or vacuum droppings.
What to Do and What Not to Do
| Do | Do not |
|---|---|
| Remove mice first, or use one-way exits | Seal holes while mice are still inside the walls |
| Use metal mesh behind sealant | Rely on foam, paper or plastic |
| Keep furnace, water heater and gas meter vents clear | Block combustion air or exhaust vents |
| Wear gloves and ventilate when working in sheds or attics | Sweep or vacuum droppings |
| Check the whole house, not just one spot | Fix one hole and assume you are done |
Edmonton Timing: When to Seal
Edmonton note: do the main check in late summer and early fall, before cold nights push mice indoors. If you are reading this in fall, seal now and check again in spring, when ground moves and snowmelt can open new gaps. Garage doors, dryer vents and roofline gaps are the most common weak spots.
When to Call a Professional
Call us if:
- You hear scratching in walls or the attic, or find droppings daily
- The gaps are high up, large or in the foundation
- You are not sure whether mice are inside before you seal
- You have sealed gaps and mice still return
- You want a photo report of every entry point found and closed
Our rodent proofing service finds and seals the entry points, and our mice control plans remove the mice and follow up. Call 780-716-3943, WhatsApp us a photo, or request a free quote. We answer 24/7.
Mice Control Plans and Prices in Edmonton
Starting prices, GST extra. You get a free quote before any work starts.
| Plan | Starting at | Includes sealing of |
|---|---|---|
| 30-Day Mice Control | $450 | Up to 5 minor entry points |
| 90-Day Mice Elimination Plan | $600 | Up to 10 minor entry points |
| 12-Month Rodent Protection Plan | $950 | Up to 10 minor entry points at setup |
Larger gaps such as foundation openings, deck skirts and rooflines are quoted separately after the inspection.
FAQs
What size gap can a mouse fit through?
A mouse can squeeze through an opening of about a quarter inch (6 mm), roughly the width of a pencil.
What is the best material to seal mouse holes?
Use materials mice cannot easily chew through, such as metal mesh or hardware cloth, copper mesh, metal flashing and cement or masonry patch for foundation gaps, with sealant to hold them in place. Foam or paper alone is not enough.
Should I seal holes if mice are already inside?
Remove the mice first, or use one-way exits, before sealing. Sealing with mice inside can trap them in the walls, where they can die or find a new route.
Can I make my house completely mouse-proof?
No building can be guaranteed rodent-free forever, but good sealing and regular checks greatly reduce the chance of mice getting in.
When should I seal gaps?
The best time is late summer and early fall, before cold nights send mice indoors. Check again in spring.
Related Reading
- Signs of mice in your house
- House mice vs deer mice in Alberta
- Why mice come inside in winter
- Rodent proofing
- Mice control in Edmonton
Want the entry points found and sealed properly? Call 780-716-3943 or request a free quote. We answer 24/7.